FUSION ASPHALT 1/2 X Random GLASS TILES
This stunning combination of marble and textured glass in nero marquina, snow white and white will give an added pop to any room with these beautiful tiles. Great to use for a backsplash for a kitchen or a fireplace.
- Chip Size: 1/2" x Random"
- Color: Nero Marquina, Snow White and White
- Material: Marble and Textured Glass
- Finish: Polished
- Sold by the Sheet - each sheet measures 12"x13" (1.08 sq. ft.)
- Thickness: 8mm
- Glass Tile -
Substrate:
Tile must be installed over a suitable substrate to insure a proper installation. Glass tile should be installed over a clean, sound, and flat surface, free of contaminates including curing compounds. Substrate should be free of cracks. If used in a wet area you must waterproof. See manufacturer’s recommendation on a membrane for crack and water protection that is compatible with the setting material you are using. Glass is reflective therefore any inconsistencies in the substrate will result in a poor installation. For pools and fountains we recommend installing a mortar bed according to TCA P601-98. EXPANSION AND CONTROL JOINTS PER TCA EJ171-05 Expansion joints should be installed at all “changes in plane” in the tile work and where tile abuts restraining surfaces, therefore silicone caulking sealant must be installed in all corner joints in place of grout.
Installation:
- To avoid affecting the color of glass tile, White modified thin-set is recommended for all installations. A second option is regular tile wall glue.
- Grout joint should be a minimum of 1/16” and not butt set.
- Apply thin-set using a trowel as recommended by the manufacturer. Apply as much adhesive as can be covered within 10-15 minutes. Once set in place gently tap using a grout float to insure full bedding and a true surface.
Grouting:
- Grout joints should be packed full and free of voids and pits.
- Clean excess grout as the work progresses before it has hardens completely.
- Acids should never be used for cleaning grout haze.
- Use a damp sponge for the final cleaning and to smooth out the grout joints.
- When grout is completely cured a grout sealer should be applied as recommended by manufacturer.
- It is recommended to use non-sanded grout.
- It is recommended to use grout release, then grout the tile, then use a sealant to the tile.
Cutting:
The recommended cutting method is to use a wet saw with a diamond blade that is specifically for cutting glass. Edges can be sanded smooth after cutting.
Disclaimer:
Due to the transparent nature of most of our tile please consider choices carefully. Tiles are handmade so variations in color and texture are to be expected. All tiles should be inspected before installation, as no adjustment will be made after installation.
Maintainance:
Glass tiles are easy to clean by wiping with a damp cloth as you would any wall or ceiling. To remove stubborn stains use a commercial nonabrasive cleaner like window cleaner or a solution of soap less detergent. The surface should be scrubbed, rinsed thoroughly with clean water and dried.
